AAI N1201SA+ 34.375-2700MHz UV RF Vector Impedance Antenna Analyzer SWR Meter

Description: Description: - This instrument has four interfaces: single point measurement, scanning, system information, correction and calibration The default boot into single-point measurement interface. Note: For the convenience of the user, each time calibration correction options will automatically change to the user calibration. Meanwhile, in order to ensure the integrity of the calibration, the calibration process, the automatic shutdown function fails, the consistent boot. Startup and shutdown: - Hold down the CTRL key off press the power switch button. - The boot state, long press (2S above) the switch button, after the release, the instrument will shut down - The boot state, long press (2S above) the switch button, after the release, the instrument will shut down Recommend the use: 1, in order to ensure the accuracy of measurement and calibration, preheat the instrument at least 15 minutes. 2, try to use good quality RF cable and connectors. 3, calibrated cable marked to the next may not need to calibrate and direct use. 4, test cable process affect the measurement accuracy, it is recommended that, where possible, do not choose too long test cable. 5, measurement and calibration before, make sure you are not in a strong wireless signal, so as to avoid interference caused by inaccurate measurements. 6, if the impedance measurements themselves do not understand, you can refer to a vector network analyzer instructions and tutorials. This instrument is equivalent to a single-port vector network analysis Specification: working currency: 140MHz~2700MHz stepped frequency: 1kHz display: 2.4inch TFT resolution: 320*240(QVGA) battery: 2000mAH(7.4Wh) power consumption: <1.5W charge current: 400mA charge port: USB auto power off can be set 5-60minutes Measured parameters: resistence reactance standing wave s11 resolution ratio: 4 number frequency accuracy: about 5ppm Connector: SMA-K Measurement range: impedance: 0.1~1000 standing wave: 1.000~65 s11(dB): 0dB~-60dB working temperature: 0~40 degree Package included: 1 x Original N1201SA Antenna Analyzer Meter 1 x English User Manual

Price: 114.99 USD

Location: Shenzhen

End Time: 2024-09-23T21:24:29.000Z

Shipping Cost: 0 USD