FIBARO Smart Implant Z-Wave Plus Plugin Universal DIY Tool, FGBS-222, doesn't...

Description: Integrate existing wired sensors in your home or business to your Z-Wave network with the FIBARO Smart Implant. This wired Z-Wave Plus module connects existing sensors using wired connections in order to add them to your Z-Wave network. The Smart Implant allows for any of the following sensor connections: (6) DS18B20 sensors, (1) DHT sensor, (2) 2-wire analog sensor, (2) 3-wire analog sensor, (2) binary sensors. To install, turn off your alarm system and sensors before connecting to the Smart Implant. Follow the included instructions to connect the Implant to a selected sensor. Once the Implant is connected, power your device and add them to the Z-Wave network. NOTES: For indoor use only. Do not place the Implant antenna near metallic components in order to avoid signal interference. Manufacturer #: FGBS-222. Power supply: 9-30V DC+/-10 percent. Inputs: 2 0-10V or digital inputs, 1 serial 1-wire input. Outputs: 2 potential-free outputs. Supported digital sensors: 6 DS18B20 or 1 DHT22. Maximum current on outputs: 150mA. Maximum voltage on outputs: 30V DC / 20V AC +/-5 percent. Built-in temperature sensor measurement range: -55 C to 126 degrees C (-67 F to 259 degrees F). Operating temperature: 0 to 40 degrees C (32 to 104 degrees F). Radio protocol: Z-Wave (500 series chip). Radio transmit power: max. 7 dBm (EIRP). Range: up to 40m (131 ft) indoors. Dimensions: 29 L x 18 W x 13 H mm (1.14 x 0.71 x 0.51 inches).. Compatible with any certified Z-Wave or Z-Wave Plus controller Supports Z-Wave network Security Modes: S0 with AES-128 encryption and S2 Authenticated with PRNG-based encryption Works as a Z-Wave signal repeater Allows for connecting: 6 DS18B20 sensors, 1 DHT sensor, 2 2-wire analog sensors, 2 3-wire analog sensor, 2 binary sensors Built-in temperature sensor

Price: 61.8 USD

Location: Miami, Florida

End Time: 2024-09-10T22:41:54.000Z

Shipping Cost: 0 USD